I have a swimming with a sand filter. When the pump runs, I see air bubbles in the water. What's causing this? - air filter for sand rail
There is a pool, a decrease of 5 years with a bomb in Hayward.
Friday, December 11, 2009
Air Filter For Sand Rail I Have A Swimming With A Sand Filter. When The Pump Runs, I See Air Bubbles In The Water. What's Causing This?
9 comments:
Normally it is an indication of a leak on the suction side of the air is developed in the system. The most common causes are:
O-ring at the top of the pot to the pump is defective. (Take It Off "and pull it through your fingers while tightening. When black out, a new, lubricated with a lubricant or" ... never Vaseline.
A pipe or hose connections between the skimmer and pump suction.
Check all O-rings in the trade unions in this area, with the top of the pump or a phone call ... (of course it can be difficult to find if the problem is metro ...)
Or is the water in the pool is too low, and sucked through the skimmer. Check out his slider and see if this is the case. (This happens to me with the new pump this year, I am, I need to keep the water higher than last year.)
Have you recently changed the content filter? She is so a little air into the filter and moves slowly with water can get.
Air circulation. sucktion can enter the main drain pump, pump pot, the basket, back through the skimmer and hoses. Try the pump and time 3-4 drops find anythings "sucktion page" common are O-ring pump cover, winter cap, valves, cracks. Correction of the air leak and no more bubbles.
PS Sucking silicone caulk into the cracks, as most of the pump.
Poor seals on all valves, or take the street in front of the pump or any other place on the pump. This is usually normal, as the pump continues to pump water. It is almost impossible to get a completely closed system.
Poor seals on all valves, or take the street in front of the pump or any other place on the pump. This is usually normal, as the pump continues to pump water. It is almost impossible to get a completely closed system.
It is not uncommon that the bubbles off the plane back into the bath water, but if you see a lot of bubbles, is probably a leak in the system somewhere. It can be as simple as a rubber seal on the pump, which is not completely closed, or it may be that the line has one skimmer, a crack in itself.
Water Oh, of course I forgot the question: Is not it enough in the pool, so that the hunters are at least half covered with water? Absorbed water, air can by scavengers, if it is not enough.
While the pump is still running, although not with, and to fill your pool every day or so obvious bubbles that you see is probably caused by a leak out.
Another thing, some pools are configured with the air bubbles in the water again to give a kind of mix whirlpool effect in the water. You probably know if you have such a system, but if you do not know, ask the kids swimming next time you open or close your pool. They are generallywilling to discuss your system with you. Good luck!
Check the filter rule cover pump is put a little grease on the plate.
If bubbles still all the joints of the intake valve, a quick way to find a leak on the suction side of the water in a can or hose with valve and pump motor seal. If you find a leak with this method, the bubbles are sucked in the water instead of air-stop is in the system.
There are two common causes. Leak and that a majority of the responses I see seems to be covered. The other is more likely to ingress of air into the system temporarily from the skimmer, or because the shallow water or in the process of vacuuming and emptying the trash pump. With these possible causes is not a cause for concern.
You may know one of these options, rather than the problem of "leakage" that indicates whether the bubbles do not occur until after the suction of the pool.
When you have replaced the last time, clean sand or spiders?
Post a Comment